Programme 09 · One month · 102 hours
Water Supply Automation and Pump Controllers
Based on Ampushworks’ own work with water-supply schemes, this course shows how pumps are controlled automatically, protected against faults and monitored remotely using GSM and IoT. Candidates work with Ampush ProSmart controllers.
Duration1 month per programme
Course fee₹3,000 per candidate
Training hours102 hours: theory 32, practical 64, exams 6
Batch sizeMinimum 10 candidates per batch
Course objectives
- Describe the components of a water-supply scheme
- Use level sensors and float switches for pump control
- Explain pump controller logic and protection
- Set up GSM/IoT remote monitoring
- Install and test an automatic pump control system
Prerequisites: Basic electricity. Knowledge of motor starters is helpful.
Hours distribution
| Component | Hours |
|---|---|
| Theory classes (8 units × 4 h) | 32 |
| Practical sessions (14 labs × 4 h) | 56 |
| Mini project | 8 |
| Theory examination | 2 |
| Practical examination | 4 |
| Total | 102 |
32 hours
Theory syllabus
| Unit | Topics | Hours |
|---|---|---|
| Unit 1 | Water-supply schemes
| 4 |
| Unit 2 | Pumps and motors
| 4 |
| Unit 3 | Level sensing
| 4 |
| Unit 4 | Pump controller logic
| 4 |
| Unit 5 | Motor protection
| 4 |
| Unit 6 | GSM and IoT monitoring
| 4 |
| Unit 7 | Ampush ProSmart controllers
| 4 |
| Unit 8 | Installation and maintenance
| 4 |
64 hours
Practical sessions
| Lab | Practical assignment | Hours |
|---|---|---|
| 1 | Identify components of a pump control system | 4 |
| 2 | Float switch based tank filling | 4 |
| 3 | Level sensor installation and testing | 4 |
| 4 | Automatic start/stop with tank level | 4 |
| 5 | Timer-based pump scheduling | 4 |
| 6 | Dry-run protection test | 4 |
| 7 | Voltage and phase-failure protection test | 4 |
| 8 | Overload protection setting | 4 |
| 9 | SMS control and status of a pump | 4 |
| 10 | IoT dashboard for pump monitoring | 4 |
| 11 | Configure an Ampush ProSmart controller | 4 |
| 12 | Remote monitoring and alerts with ProSmart | 4 |
| 13 | Commissioning checklist practice | 4 |
| 14 | Fault-finding in a pump control system | 4 |
| MP | Mini project: Complete automatic water-supply control: level-based pump control with protection and GSM/IoT remote monitoring. | 8 |
| Total practical hours | 64 |
Hardware, tools & software
- Ampush ProSmart pump controllers
- Float switches and level sensors
- Test pump/motor set-up and starter panel
- GSM SIM and IoT dashboard
Learning outcomes
- Design and wire automatic pump control
- Apply protection against common pump faults
- Configure GSM/IoT remote monitoring
- Install, commission and maintain a pump controller
Assessment & certificate
| Examination | Duration |
|---|---|
| Theory: concepts, components and principles from the 8 units | 2 h |
| Practical: build, wire, program, test, fault-find; mini project presentation | 4 h |
A training completion certificate is issued subject to successful completion of the programme and assessment requirements.
📄 Download this syllabus: English PDF · हिंदी PDF